
Electro Galvanized Steel Plate
Electro Galvanized Steel Plate in a full range of sizes and grades, with stock lengths, cut-to-length service, third party inspection and mill test certificates on request. Send your size list and destination port for a quote within 12 hours.
Ask a paint shop why it prefers electro galvanised sheet over hot dip and the answer is usually about the surface rather than the zinc. Electro galvanised sheet comes out smooth and even, takes a coating without a preparation step, and holds dimensional tolerances through the process because nothing is heated. For visible parts that will be painted indoors, those three points decide the choice long before corrosion figures are compared.

Zinc applied by electrolysis rather than by dipping
In electro galvanising the zinc is deposited electrolytically at room temperature rather than by immersion in a molten bath. Because no heat is involved, the steel does not distort, and tight tolerances survive the coating operation intact. Zinc itself is an active metal that reacts with oxygen in the air to form a dense oxide film, and that film is what stands between the steel and further corrosion; on an electro galvanised surface the layer is thinner but far more precisely placed than on a dipped sheet.

Coating thickness and what it buys
Coating thickness on electro galvanised sheet runs from 3 to 20 μm, which is thin and closely controlled. That thinness is what keeps the material economical, because less zinc is consumed per square metre, and it is also the reason this product suits indoor and mild environments rather than long outdoor exposure. Hot dip galvanised sheet, by comparison, carries 40 to 200 μm of zinc and is the better answer where the part faces weather, salt or abrasion. The heavier coating lasts longer in exposure, but it also brings a rougher surface, a risk of distortion from the heat of the bath into the strip, and higher consumption of zinc and energy.
Why the surface suits painting
The finish off an electro galvanising line is smooth, uniform and bright, and that is exactly what a paint or lacquer system needs to look right. Visible parts benefit twice: the coating covers evenly, and the panel does not carry the spangled texture that a dipped sheet shows. Where a part is bent after coating, the electro galvanised layer is ductile enough to follow the bend without cracking, while the brittle zinc-iron alloy layer on a hot dipped sheet can fail at a tight radius.

Where electro galvanised wins, and where it does not
Automotive panels, electronics housings and appliance casings are the natural fit, along with roofing components that are sheltered from direct weather. Where the part is a structural item in an exposed location, a construction component, infrastructure work or farming equipment, the thicker hot dip coating is the right material, and the rougher surface is an acceptable price for the extra zinc. The decision is not about which product is better; it is about which exposure the part will actually meet.
Setting the enquiry up properly
Say which face will be seen, whether the sheet will be painted or left bare, whether it will be bent after coating, and what the part will be exposed to. With those four points, the coating process, the coating thickness and the surface finish can be confirmed together, and the plate can be quoted with a specification that matches the job rather than a general purpose one that has to be over-specified to be safe.

Hot Tags: electro galvanized steel plate, electro galvanized steel plate price, electro galvanized steel plate supplier, buy electro galvanized steel plate, electro galvanized steel plate specification, galvanized steel sheet exporter, DX51D Galvanized Iron Coils Gi Steel Sheet, 22 Gauge Galvanized Sheet Metal 4x8, Z275 Galvanised Metal Sheets 0 2mm, Zinc Coated Galvanized Steel Sheet DX51D, 1mm Gi Sheet, 1 5 mm Galvanised Steel Sheet
Send Inquiry










