
Black Steel Flat Bar
Black Steel Flat Bar in a full range of sizes and grades, with stock lengths, cut-to-length service, third party inspection and mill test certificates on request. Send your size list and destination port for a quote within 12 hours.
Ask a saw operator which stock he would rather cut and the answer comes fast: flat bar off the rack, not plate off a burning table. The bar arrives with blunt edges, flat faces and a section that already matches the part, so a bandsaw takes it to length in one pass and the punch press accepts it straight from the stack. That is the whole argument for buying black flat bar as a finished section instead of cutting strips from plate - less cutting, less dressing, less scrap going back to the yard.

What black flat bar is, exactly
It is a rectangular section rolled or slit to a controlled width between 12 mm and 300 mm, with thickness from 3 mm to 60 mm and slightly blunted edges. Black means as-rolled: no pickling, no coating, just the oxide skin the mill left behind. That finish welds and machines without the surface preparation a bright or coated bar needs, and it takes primer or paint without adhesion problems as long as the scale is removed first.
Sections that move fastest
Most of the tonnage leaves in five sizes: 20 x 3 mm, 50 x 5 mm, 80 x 6 mm, 100 x 10 mm and 120 x 12 mm. Those cover hoop iron, frame bracing, machinery keys and general fabrication stock. Anything outside them is still rolled to order, but the lead time on a non-standard section is a mill question rather than a stock question, so tell us the size list early if the schedule is tight.
Material choices across the range
Q235 and Q345 cover the structural work, and they behave predictably under welding and bending. When the application is wet, coastal or hygienic - food equipment, marine trim, chemical skids - the same section is available in 304 and 316 stainless steel, where the job stops being about strength and starts being about the environment. Mixing the two families on one order is common and we keep the bundles separated and tagged so the shop does not confuse them.

Protection when the bar has to go outdoors
Black bar stored under cover holds for a long time. On site, though, it needs help. Three routes are used in practice: hot dip galvanizing for buried or permanent steelwork, spraying with a primer or zinc-rich paint for fabricated assemblies, and chemical treatment where a thin conversion coating is enough. Hot dip galvanizing gives the longest life and is worth the extra handling on anything that will not be painted later.
Where the bar is used
Construction consumes it as hoops, frame members, bracing and escalator parts. Equipment builders use it for brackets, guards and machine bases. Industry takes it for boiler and pressure vessel support work, where the flat contact face matters. Decorative work - railings, grilles and furniture frames - uses the same bar with a different surface finish.

Questions from the fabrication shop
Is the edge square enough to weld without machining? Yes. The edges are rolled slightly blunt rather than razor sharp, which is what keeps handling cuts down and lets a fillet weld sit properly.
Can lengths be cut to the part list? Cut-to-length is standard. Send the cut list with the section sizes and we will return the piece count and the offcut position so your nesting matches ours.
Send the section list with quantities and we will come back with the material, the lengths and the finish.
Hot Tags: black steel flat bar, black steel flat bar price, black steel flat bar supplier, buy black steel flat bar, black steel flat bar specification, flat bar exporter, Wholesale Carbon Steel Flat Bar, A36 Flat Bar, Hot Rolled Mild Carbon Alloy Steel Flat Bar, Steel Slotted Flat Bar, Galvanised Flat Bar, MS Flat Iron Bar
Send Inquiry












