
Cold Rolled Steel Plates 0.5mm
Cold Rolled Steel Plates 0.5mm in a full range of sizes and grades, with stock lengths, cut-to-length service, third party inspection and mill test certificates on request. Send your size list and destination port for a quote within 12 hours.
The pickling line is where a cold rolled programme is either set up well or set up for trouble. The incoming hot rolled coil has to arrive without surface oxide defects or cracks, and its chemistry has to be right for rolling - if carbon, manganese or silicon sit outside the band the mill was set up for, the strip will fight the rolls and the finished sheet will show it. Half a millimetre is thin enough that the incoming coil specification stops being a formality.


What the line expects from the incoming coil
The raw material is hot rolled steel coil, usually between 1.5 mm and 6.0 mm thick and up to 2000 mm wide. It has to be free of obvious defects such as oxide scale and cracks, and the chemical composition has to meet the requirements of cold rolling. The oxide layer is then removed by pickling, which is what makes the later surface achievable in the first place - no amount of finishing recovers a clean surface from a coil that arrived with rolled-in scale.

Cold rolling, then annealing to give the ductility back
Rolling happens at room temperature and thins the strip while improving surface accuracy. That process work hardens the steel, so the coil is annealed afterwards to eliminate the work hardening and restore plasticity and formability. Finishing then adjusts flatness and surface condition. The order of those steps is fixed, and a sheet that has been annealed to the wrong cycle will press differently from one that has been annealed correctly, even though the thickness and the analysis are identical.


Why half a millimetre suits a press shop
Sheets at this thickness combine exceptional stamping performance with a low yield point and good anti-aging behaviour. A low yield point means the material starts to flow at a lower stress, so the press does not have to be oversized and the die sees less wear. Anti-aging matters for stock held between forming and assembly, because a sheet that ages badly becomes harder and less predictable over time on the shelf.

Surfaces that can go straight into coating
The sheets come off the line with excellent flatness, superior smoothness and a clean, bright finish. That is what allows them to be used as the base material for organic coated steel plate, where the coating layer is only as good as the surface it sits on. It also means a customer can move straight to painting, printing or lacquering without an extra preparation step, and that printed steel drums get an even base for their artwork.

Where these sheets are specified
Automotive manufacturing takes a large share, as do printed steel drums, construction and building materials, and bicycle production. In each case the sheet is chosen less for its strength than for its flatness and its surface, since the value is added later by a coating or a forming step. Tell us the thickness, the intended forming operation and whether the surface will be coated or left bare, and we will confirm the annealing condition, the tolerance and the delivery schedule with the offer.

Hot Tags: cold rolled steel plates 0.5mm, cold rolled steel plates 0.5mm price, cold rolled steel plates 0.5mm supplier, buy cold rolled steel plates 0.5mm, cold rolled steel plates 0.5mm specification, cold rolled steel sheet exporter, SPCC 0 2mm Cold Rolled Steel Sheet, Cold Rolled Steel Plates 0 5mm, Cold Rolled Mild Steel Sheet, Mild Steel Cold Rolled Sheet, Cold Rolled Carbon Steel Mild Sheet, Cold Rolled Steel Sheet
Send Inquiry










